CO101 Regin CO Carbon Monoxide Bump Tester

Bump test commercial CO detectors

Price: $59.95

SKU:

CO101

DetailsQuestions

CO101 Regin CO Carbon Monoxide Bump Tester-- FREE Ground Shipping!

     Bump test commercial CO detectors safely and reliably with the Regin CO Carbon Monoxide Bump Tester.

     The CO101 Regin CO Carbon Monoxide Bump Tester uses no aerosol! It concentrates and filters carbon monoxide produced by the popular Regin S220 Smoke Pen and presents it to commercial CO detectors using a convenient hand-held adapter that fits most commercial CO detector units.

     Once lit and producing CO at 800 to 1000 ppm, the Regin CO Bump Tester will perform test after test for up to 30 minutes. Each unit comes with 6 replacement wicks, affording a full three hours of continuous or intermittent testing time. Packs of additional replacement wicks are available.

     Tired of paying around $3.00 per test bump-testing your CO detectors with canned CO? Drop that to around 10 cents per test with the Regin CO Bump Tester!

The Regin CO Bump Tester is an eco-friendly alternative to canned, aerosol CO test products. It ships safely and economically by ground or air anywhere in the world--no restrictions, no extra handling charges.

Package Contains:

1 Smoke-Pen ( re-usable )
1 CO-Adapter unit
6 Replacement CO-Wicks (re-fills available)
1 Replacement filter that is Pre-mounted in CO-Adapter (re-fills available)

Watch CO101 Regin CO Bump Tester in Action!

Directions:

Remove the soft black cap from the end of the pen
Place a CO-Wick in the pen by pressing the button on the end of the pen to open the jaws.
Adjust to allow approximately 3/8" of exposed wick.
Light the tip of the wick and allow it to burn for 10-15 seconds, blow out the flame and the pen will provide continuous generation of CO gas.
Insert Smoke-Pen in rubber holder on CO-Adapter as image 4 below, press firmly into place.
Make sure filter part is mounted as images 1-2, NOTE do not push finger directly against paper filter surface, this may break it.
As long as you have a trail of smoke coming out of evacuation hole on top of CO-Adapter (image 3) the unit produces CO gas at marked outlet opening. CO level is between 300-1000 ppm.
Extinguish the CO-Wick by simply release the Pen from the rubber holder and replacing the soft plastic cap over the wick end of the pen.
To re-use, simply adjust the length of the wick and follow the steps as described above.